LME:
2.698,07 €
-0,48 %
-13,1100 €
HUF/EUR:
363,72
-0,14 %
-0,5000 Ft
HUENDEROHRSK
Log in |
ACH
LME: 2.698,07 € ↘︎ -0,48 % -13,1100 €
HUF/EUR: 363,72 ↘︎ -0,14 %
Log in
HUENDEROHRSK
EN AW-5083 (AlMg4,5Mn0,7) – cast, milled aluminium plate (precision tooling plate)
Cast and milled aluminium plates

EN AW-5083 (AlMg4,5Mn0,7) – cast, milled aluminium plate (precision tooling plate)

AlMg4,5Mn0,7-based, cast and milled on both sides, stress-relieved precision plate. Homogeneous structure, excellent flatness and thickness tolerance, with reliable machinability and good corrosion resistance.

  • Factory milled on both sides, with protective film – precision surface, tight dimensional accuracy.
  • Stress relieved – excellent dimensional stability during and after machining.
  • Good machinability – ideal for tooling plates, vacuum tables and machine bases.
  • Excellent shape and dimensional retention – before / during / after machining
Alloy grade
EN AW-5083 (AlMg4,5Mn0,7) – cast, milled
Product form
Precision cast plate, milled on both sides, with protective film
Thicknesses
Thickness tolerance: +/-0.1 mm
Formats
Plate form, surface milled on both sides

EN AW-5083 – chemical composition1

(EN 573-3)

Specifications (%)

Remainder: Aluminium

 Others
Si Fe Cu Mn Mg Cr Ni Zn Ti Ga V Notes Each Total2
0,40 0,40 0,10 0,40 - 1,00 4,00 - 4,90 0,05 - 0,25 - 0,25 0,15 - - - 0,05 0,15
1 Chemical specifications are in mass %. Where no range is given, the alloying content is the maximum value.
2 Includes all elements for which no separate limit is specified.

There are no governing EN standards for cast and cast, milled plates (except for chemical composition), and the plates of individual manufacturers are not produced to the same (physical) parameters – often according to “in-house standards”.

The technical datasheets of the cast, milled plates distributed by Alu-Cutting Hungary Zrt. are available via the links below.

Öntött, síkba mart alumínium lemez 5083
Öntött, síkba mart alumínium lemez 5083
Öntött, síkba mart alumínium lemez 5083
Technical Data Sheet (TDS)
Back to the previous page
Note: We accept no liability or warranty for the correctness, accuracy or completeness of the information and data stated above. Standards and indicative values may change. Agreements are valid as set out in the quotation / order confirmation. We also draw attention to the fact that we accept no liability for colour shades arising during decorative anodising, or for corrosion-resistance results and how they develop. Individual terms may be agreed on a case-by-case basis and must be recorded in writing.